of liquid for visibilty (albiet poor visibility). You need to cut back the gelatin to about 1TB gelatin per 2c. You can't get clear, unmoldable jello in the scale that I was dealing with. Held it at 95☌ (203☏) overnight, then tried a couple of hours at 99☌ (210☏).
#Clear gelatin for gelatin art full#
(I was using an immersion circulator for heating, so I never took it to a full boil. Although Gelatin has a tint, the Agar isn't fully transparent when it sets, even after holding it for hours at temperatures just off the boil. Gelatin has better visibilty than Agar-Agar. (a bottle that I had in storage for a year was considerably more apple-juice like in color than a more recent purchase). (the best flavoring I could find was 'white cranberry' beverage (10% juice), but noticed there seemed to be variance over time in the color. (it clears up some after heating it's absolutely horrible if you try mixing it in at the end) Oil based flavorings had no emulsifier, and would just separate out. Alcohol-based extracts will make it more murky.
(I used a spoon to deflect the pour to right near the wall of the container).Īvoid flavorings. If you still have a few remaining after it's set, you can pour the hot liquid on the bubbles to remove them from that layer. If you pour it in layers, slowly move a fork through the top to pop and bubbles. 170☏ (77☌) was fine, but even taking it down to 160☏ (71☌) resulted in a good bit of murkiness (likely introduced by small air bubbles when pouring I might have had better luck with more careful pours, or using alternate means to move the liquid (eg, syringe)). You need to pour the gelatin while it's quite hot.
(30 min was my minumum test, it might've been possible with less time)
I found 180☏ (82☌) for 30 min would make sure that the gelatin was properly disolved, so that it would minimize the murkiness. Heating the gelatin for a long time is very necessary. After many, many tests, I have discovered a few things:
0 kommentar(er)
